Close

SW1002

SP - DT

The SW1002 is a single pole double throw contactor designed for use in telecommunication and power distribution applications where an uninterrupted load is switched.  These contactors are primarily for use with Direct Current loads but can also be used with Alternating Currents.

The SW1002 features double breaking main contacts with silver alloy tips which are weld resistant, hard wearing and have excellent conductivity.  Silver plating on the main contacts is standard for the SW1002, however, optionally it can be excluded from the specification.  This contactor can be busbar mounted vertically or horizontally, but if mounted vertically, the coil should be at the bottom.  We recommend that mounting orientation is stated where possible during contactor specification process.

 

SW1002 Technical Information

Application
InterruptedRating ( Ith )Uninterrupted
Thermal Current Rating - 1200A
Intermittent Current Rating:
30% Duty - 2190A
40% Duty - 1895A
50% Duty - 1695A
60% Duty - 1550A
70% Duty - 1435A
Rated Fault Current Breaking Capacity (Icn) 5ms Time Constant: (In accordance with UL583*)
Blowouts -
No Blowouts -
Rated Fault Current Breaking Capacity (Icn) Resistive Load: (In accordance with UL508*)
Blowouts -
No Blowouts 1800A at 60V D.C.
Maximum Recommended Contact Voltages
Blowouts - -
No Blowouts - 60V
Typical Voltage Drop per pole across New Contacts at 1200A 50mV

Mechanical Durability > 1,000,000 Cycles
Coil Voltage Available (Us) (Rectifier board required for A.C.) 6 - 240V

SW1002 Features

Component Configurations
Auxiliary
STANDARD
STANDARD - GOLD
V3
V3 - GOLD
Coil Suppression
DIODE
DIODE AND RESISTOR
BI-DIRECTIONAL DIODE
Coil Terminations
AMP TAGS
FLYING LEADS
VACCUM IMPREGNATION
Mounting Options
'L' Shaped Bracket Kit
M5 Tapped Holes

Aïe ! Nous n’avons pas retrouvé votre formulaire.